Set Up Your Disks

clip_image002

The first step you need to do is backup your information on the disks you want to use in the RAID. While it is not required that you format your disks for some of the RAID options, don’t take the chance and make a backup.

Once all of your information is backed up, open your start menu, right click on computer and open manage.

clip_image004

When computer management opens click on disk management on the left side. Any disk you want included in your RAID you need to delete them from the top area of disk management.

clip_image006

Once they are deleted you should only be left with disks you do not want included in the RAID. The other disks will still be there but they will show up in the lower pane and show their spaces as unallocated.

clip_image008

Create Your RAID

In Windows they don’t call their RAID options by the traditional 0, 1, 5, 10 etc. Instead they use spanned, striped, and mirrored as the options for creating software RAIDs.

Note: RAID-5, although one of the options, isn’t actually available in Windows 7 due to licensing issues. Thanks to the commenters for pointing that out.

A spanned volume will create a single partition that will literally span all of the included disks whereas a striped volume will deliberately break up files across multiple disks in an attempt to improve read and write performance. In both cases there is no redundancy so you need to create your own backups.

A mirrored volume and RAID 5 both have some redundancy but you lose storage space to create the parity files needed for recovery. For this example we are going to go with the simplest volume type and create a spanned volume even though it isn’t technically RAID.

Right click on the first disk you want included in your RAID and select new spanned volume.

clip_image010

or for RAID 5 select raid 5

This will open up the New Spanned Volume Wizard in Windows. Click next and then select which disks you want included in your new volume (a.k.a. software RAID).

clip_image012

or for RAID 5

image

Assign the new volume a mount letter or mount point.

clip_image014

Name and format the volume and click next.

clip_image016

The final step just reviews all of your settings before the disks are formatted and the new volume is mounted.

clip_image018

You should also receive a warning letting you know that if your operating system is on one of these volumes you won’t be able to use it because the volume is now a dynamic volume instead of a logical volume.

clip_image020

Finally the disks will be formatted and once the drive is mounted you should be welcomed with the familiar AutoPlay prompt.

clip_image022

If you browse to Windows explorer you should also see that the new volume has the combined storage space of the three individual disks used to create it.

clip_image024

Leave a Reply